Framing takeoff: studs, plates and headers from a floor plan
A wall framing takeoff starts with one number, the linear feet of wall, and builds the rest from it: studs, plates, headers and sheathing. This guide covers walls. Floors and roofs work the same way, with joists and rafters counted from spans and spacing.
Step 1: Linear feet of wall, by type
Measure exterior and interior walls separately, and split them wherever the stud size or wall height changes: a 2×6 exterior wall and a 2×4 partition take different lumber, and so do 8 ft and 9 ft walls. Mark the bearing walls too. Their headers are structural, and the sizes come from the plans or the engineer, not from the takeoff.
Step 2: Studs
The quick rule is one stud per linear foot of wall. At 16 in. on center the layout alone needs 0.75 studs per foot; the extra covers corners, wall intersections, and the king and jack studs at each opening. The Journal of Light Construction's lumber guide gives one stud per foot for houses under about 2,000 sq ft and 1.25 per foot for larger ones.
For a tighter count, go wall by wall: the wall length in inches ÷ 16, plus one, for the layout, then add the studs your crew uses at each corner, each intersection and each opening.
Step 3: Plates
A bottom plate and a double top plate make three plates per wall, so plate stock = 3 × wall length. Bottom plates on concrete are usually pressure-treated lumber, so list them as their own line. For 180 linear ft of interior wall, that's 540 linear ft of plate.
Step 4: Headers
Count every door and window from the schedules, plus cased openings. Header length is the rough opening plus 3 in. when there's one jack stud on each side, or plus 6 in. with two. A 36 in. rough opening with single jacks takes a 39 in. header; multiply by the number of plies in your header detail.
Step 5: Wall sheathing
Sheathed wall area ÷ 32 gives the number of 4 × 8 sheets. Use the height that actually gets sheathed, which can include the rim joist. 140 linear ft of exterior wall at 8 ft is 1,120 sq ft, or 35 sheets before waste. As with drywall, many estimators deduct only large openings and add waste for cuts.
Check it before it goes out
- Studs per linear foot land near your rule. Far above or below usually means a wall counted twice or missed.
- The header count matches the door and window schedules, plus cased openings.
- Plate footage is three times the wall footage, plus any extra plates your details call for.
Doing it in IQ Builders
The takeoff's rough-in items measure interior and exterior walls in linear feet, and the door and window counts give you the header count, all from the plan sheet. Upload the PDF plans and set the scale by clicking two points on a known dimension. The quantities go into the estimate's line items, so nothing gets retyped. Manual measurement is part of the Ultimate plan.
With the AI Takeoffs add-on, available on any paid plan, the AI counts the doors and windows and marks each one on the plan. You confirm the marks before they go into the estimate. Estimates and invoices are free on the Starter plan. See pricing.
Quick reference
| Item | Rule of thumb |
|---|---|
| Studs (16 in. on center) | about 1 per linear ft of wall; 1.25 for larger houses |
| Plates | 3 × wall length (bottom plate plus double top plate) |
| Header length | rough opening + 3 in. with single jacks, + 6 in. with double jacks |
| Wall sheathing | sheathed wall area ÷ 32 for 4 × 8 sheets, plus waste |
New to measuring from PDFs? Start with how to do a construction takeoff from a PDF plan. Prefer a spreadsheet? Use the free estimate template.
More trade guides: drywall, painting, electrical.