Electrical takeoff: counting devices and fixtures from a plan
An electrical takeoff has two parts: counting everything drawn as a symbol, such as receptacles, switches, lights and detectors, and measuring the wire runs between them. The counts drive the device and fixture cost and much of the labor, so they need to be exact.
Step 1: Read the legend first
Every electrical plan has a symbol legend. Read it before you count: a standard duplex receptacle, a GFCI receptacle and a weatherproof receptacle can differ by one small mark, and each has a different price. Check the fixture schedule too. It lists each fixture type and sometimes the quantities.
Step 2: Count one symbol type at a time
Count one type across the whole sheet before you move to the next, and mark each symbol as you count it, so nothing gets skipped or counted twice. Lights are usually on the reflected ceiling plan or a lighting plan and receptacles on the power plan; on smaller jobs they're often on one sheet.
Step 3: Boxes, plates and switch types
Every device needs a box and a cover plate, so count those from the devices. A multi-gang location is one box holding several devices. Keep three-way and four-way switches on their own lines: they cost more and take more wire than single-pole switches.
Step 4: Runs and wire
Measure the home run from each circuit to the panel and the runs between devices, then add for the drops down to each box and the slack left at each box. On houses, many electricians price per device or per opening from their own job history instead of measuring every run.
Step 5: What the plans leave out
Service, panel, feeders and grounding are often shown only as notes. Smoke and CO detectors, dedicated circuits and arc-fault and ground-fault protection follow the code your inspector enforces. Check them before you price, because they rarely show up in a symbol count.
Check it before it goes out
- Fixture counts match the fixture schedule where there is one.
- Every room has the receptacles and lights you'd expect. A bedroom with no receptacles counted is a missed symbol, not a design choice.
- Devices per square foot of floor are in line with your last few similar jobs.
Doing it in IQ Builders
The count tool marks each symbol on the sheet as you click it, so you can see what's counted and what isn't. There are ready-made count items for outlets, light fixtures, recessed and track lights, pendants and sconces, and the counts go into the estimate's line items. Upload the PDF plans and set the scale by clicking two points on a known dimension to measure runs. Manual measurement is part of the Ultimate plan.
The AI Takeoffs add-on, available on any paid plan, is set up to count electrical items only where symbols are drawn on the plan or listed in a schedule, and not to estimate them from room sizes. Treat its count as a first pass and check it. Estimates and invoices are free on the Starter plan. See pricing.
Quick reference
| Item | Rule of thumb |
|---|---|
| Before counting | read the legend and the fixture schedule |
| Devices and fixtures | count one symbol type at a time, marking each one |
| Boxes and plates | one box per device location; multi-gang is one box |
| Switches | single-pole, three-way and four-way on separate lines |
| Wire | home runs plus device-to-device runs, drops and slack, or your own per-device rate |
New to measuring from PDFs? Start with how to do a construction takeoff from a PDF plan. Prefer a spreadsheet? Use the free estimate template.